The rear panels are available for repair. The front side of the rear cab corners are not available as repair parts.
What is the repair procedure for these panels?
Make them yourself?
Just weld in a flat repair panel?
[image]441[/image][image]442[/image]
I will look into getting some made.
Any interest in anyone needing some replacement panels?
I’m thinking of getting a long sheet made of the correct form and just cut off the length. Then just pinch flat at the bottom spot weld.
Cab corner repair
Moderator: FORDification
-
BobbyFord
- 100% FORDified!
- Posts: 5372
- Joined: Sun Feb 04, 2007 9:52 am
- Location: Chatsworth, California
Re: Cab corner repair
Fab them yourself. I'll be tackling this soon.
-
Ranchero50
- Moderator
- Posts: 5799
- Joined: Wed Nov 08, 2006 7:02 pm
- Location: Maryland, Hagerstown
- Contact:
Re: Cab corner repair
Ditto or find a donor and cut them out. That's the route I took. Old box trucks are good candidates.
'70 F-350 CS Cummins 6BT 10klb truck 64k mile Bahama Blue
Contact me for CNC Dome Lamp Bezels and Ash Tray pulls.
Contact me for CNC Dome Lamp Bezels and Ash Tray pulls.
-
tsherry
- Preferred User
- Posts: 487
- Joined: Fri Dec 23, 2005 11:26 pm
- Location: Washington, Spokane
Re: Cab corner repair
Fab it up from a good section of a box floor.
too many Fords, no where near 'nuff time.
or, money.
or, money.
-
Manny
- Blue Oval Guru
- Posts: 1190
- Joined: Wed Oct 04, 2006 7:15 pm
- Location: Georgia, Lake City
- Contact:
Re: Cab corner repair
This is one i am gonna have to handle as well... Does bed floor fix it well??? actually look right? 
Just another Ford fool named Dan.
The Junk that hangs around
67' F-250 highboy Camper special cross breed currently under way
http://www.fordification.com/forum/view ... 22&t=86706
1974 Bronco 302 3 speed
1984 bronco 302 c6 35's
1994 F350 7.3 5spd dually.
The Junk that hangs around
67' F-250 highboy Camper special cross breed currently under way
http://www.fordification.com/forum/view ... 22&t=86706
1974 Bronco 302 3 speed
1984 bronco 302 c6 35's
1994 F350 7.3 5spd dually.
woods wrote: The rust holes in my truck were a factory install (very rare).
-
austin
- Blue Oval Fan
- Posts: 572
- Joined: Mon May 04, 2009 11:30 pm
- Location: Utah, Moroni
Re: Cab corner repair
I fabbed mine out of a sheet of 12 gauge iirc and I just used basic hand tools, it was good enough for the girls I go with