I made a batch of 10 of these support struts for our highboy's, to keep the dana 24 from swinging back and forth under load as they commonly do. Made them quite a while ago now, and sold all but one to members of this forum. Then i pulled my personal one off after switching to a np205 transfer case, so i have these two struts that i just dug up while cleaning the garage out.
The support strut, sandwhich rubber and plate are there for each one, just missing hardware (bolts, nuts, washers, etc.).
You may notice in the picture one has a .120 wall stub tube and the other .250. This is just because the on that was on my truck got made at a different time than the batch i made. The .120 wall one is more than strong enough.
$40 shipped each.
